Abstract
To enable the use of additively manufactured polymer materials as structural and insulating components within high-voltage pulsed power systems, a better understanding of material compatibility with common pulser material environments is required. This work examines the effect of long-duration contact of printed polymeric components with three high-voltage insulating oils (Shell Diala S2 ZX-A, Luminol TRi, and Royco 602) at room temperature (~25 °C). Test pieces printed using stereolithography (SLA) were evaluated for changes in dielectric strength, mechanical properties, and composition after submersion in insulating oil for a nine-month duration. Gas chromatography–mass spectrometry (GC–MS) was used for compositional analysis on neat and polymer-exposed oils to identify compositional changes that occurred in the oil over the course of the exposure period.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
