Compatibility of ITER scenarios with full tungsten wall in ASDEX Upgrade

Abstract

The transition of ASDEX Upgrade (AUG) from a graphite device to a full tungsten device is demonstrated with a reduction by an order of magnitude in both the carbon deposition and deuterium retention. The tungsten source is dominated by sputtering from intrinsic light impurities, and the tungsten influxes from the outboard limiters are the main source for the plasma. In H-mode discharges, central heating (neutral beams, ECRH) is used to increase turbulent outward transport avoiding tungsten accumulation. ICRH can only be used after boronization as its application otherwise results in large W influxes due to light impurities accelerated by electrical fields at the ICRH antennas. ELMs are important in reducing the inward transport of tungsten in the H-mode edge barrier and are controlled by gas puffing. Even without boronization, stationary, ITER baseline H-modes (confinement enhancement factor from ITER 98(y, 2) scaling H98 ∼ 1, normalized beta βN ∼ 2), with W concentrations below 3 × 10−5 were routinely achieved up to 1.2 MA plasma current.The compatibility of high performance improved H-modes with unboronized W wall was demonstrated, achieving H98 = 1.1 and βN up to 2.6 at modest triangularities δ ⩽ 0.3 as required for advanced scenarios in ITER. With boronization the light impurities and the radiated power fraction especially in the divertor were reduced and the divertor plasma was actively cooled by N2 seeding. N2 seeding does not only protect the divertor tiles but also considerably improves the performance of improved H-mode discharges. The energy confinement increased to H98-factors of 1.25 (βN ∼ 2.7) and thereby exceeded the best values in a carbon-dominated AUG machine under similar conditions. Recent investigations show that this improvement is due to higher temperatures rather than to peaking of the electron density profile.Further ITER discharge scenario tests include the demonstration of ECRF assisted low voltage plasma start-up and current rise to q95 = 3 at toroidal electric fields below 0.3 V m−1, to achieve a ITER compatible range of plasma internal inductance of 0.71–0.97. The results reported here strongly support tungsten as a first wall material solution.