Abstract
This paper demonstrates the comparisons of molding with micro molds made of different elastomeric polymers. Micro molds made of pure polydimethylsiloxane (PDMS), 0.3% carbon nanotube (CNT) enforced polydimethylsiloxane (PDMS), 2% carbon nanotube (CNT) enforced polydimethylsiloxane (PDMS) and commercial available high temperature silicon rubber sheet (Avon Group) were studied. Micro moldings using different molding pressures were performed. By comparing the dimensions of micro features produced with different molding pressures, molding accuracies of using micro molds made of different elastomeric polymers are obtained. Results of this study provide valuable information for the development of elastomer micro mold insert for micro injection molding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.