Comparison of zona cutting and zona drilling as techniques for assisted fertilization in the mouse.

Abstract

Zona cutting and zona drilling of the mouse oocyte significantly increased the fertilization rate (3.8-90%) at low sperm concentrations (less than 200,000/ml) compared with zona-intact controls (0-45%). More oocytes were fertilized after zona drilling. Zona cutting was associated with a low loss of oocytes (less than 1%), no increase in polyspermy and normal development in vitro and in vivo after fertilization. There was a 4% oocyte loss rate after zona drilling, mostly due to extrusion of the oocyte from the zona during the procedure. Hatching of blastocysts occurred about 12 h earlier for zona-drilled than for zona-cut and zona-intact control oocytes. Zona drilling was associated with a higher, but not statistically significant, rate of polyspermy at all sperm concentrations tested. The proportion of zygotes developing to the blastocyst stage was not different between the techniques (zona cut, 77%; zona drilled, 66%; control, 71%). Similarly, no difference was found in the percentage of embryos implanting after blastocyst transfer to the uterine horns of pseudopregnant female mice (zona cut, 67%; zona drilled, 68%; control, 77%). Transmission electron microscopy demonstrated the induced defects in the zona with no damage to the oocyte or oolemma. Parthenogenetic activation was not seen after either of the micromanipulative techniques. Both techniques have promise for application to the human.