Comparison of trans-cortical and cancellous screws to press fit for acetabular shell fixation in total hip arthroplasty: A cadaveric study

Abstract

BackgroundTotal hip arthroplasty complications are associated with mechanical loosening of the acetabular component, which may be attributed to the type of fixation used (press fit, trans-cortical screws, cancellous screws). Therefore, the purpose of this study was to compare trans-cortical and cancellous screws to press fit for fixation of the acetabular shell. MethodsFive cadaveric pelvis specimens were hemisected (N = 10) at the sacroiliac joint. Each hemi-pelvis was initially tested with a press fit cup followed by the left and right pairs being randomized to either a cancellous or trans-cortical screw condition. Each fixation was tested by applying a load to a rod inserted into the centre of the acetabular cup at 0.5 mm/s, until failure occurred. The failure force, failure moment, and the rotation angle of the cup at failure were calculated. FindingsThe cups fixated with a trans-cortical screw failed at a significantly greater mean [SD] force (1046.20 [386.52] N). The trans-cortical screws also significantly increased the angle of failure 46.29 (16.90) ° compared to the press-fit cups (6.73 [4.59] °). Finally, there was a significant increase in the failure moment, such that, the trans-cortical condition failed at a mean (SD) moment of 53.75 (16.24) Nm compared to 9.59 (1.85) Nm and 32.15 (18.16) Nm for the press fit and cancellous (p = 0.044) conditions, respectively. InterpretationThe acetabular shells that were fixated with trans-cortical screws provide greater stability compared to the press-fit cups or cancellous screws.