Comparison of the transverse cranial base dimension in different craniofacial skeletal relationships: A cone-beam computed tomography study

Abstract

Background/purposeIn comparing the cranial base's size, most cephalometric studies focused on the length and angle in the anteroposterior direction. However, investigating the anterior, middle, and posterior cranial base's transverse dimensions is challenging. This study aimed to investigate the transverse dimensions of the cranial base in different craniofacial skeletal patterns and sexes using cone-beam computed tomography (CBCT). Materials and methodsA total of 210 adults (105 males and 105 females), including three different skeletal relationships, were included in the study. The cranial base dimensions were measured on a three-dimensional image structure rendered by CBCT. Statistical methods included the Kappa statistic for analysis of consistency and reproducibility and the independent t-test for differences in cranial base dimensions between sexes. A general linear model (GLM) was used to compare the transverse size of the cranial base among skeletal Class I, II, and III groups. The Pearson correlation coefficient explored the correlation among the cranial base dimensions. ResultsThe cranial base dimensions did not differ significantly between skeletal Class I, II, and III. The more prominent cranial base size was found in males than females, except for the crista galli length (CGL) and cribriform ethmoid plate width (CEPW). The cranial base dimensions did not differ significantly between different skeletal relationships. Most dimensions have significant correlations in the middle and the posterior cranial base. ConclusionThe cranial base's transverse dimensions in Taiwanese adults show no significant differences between craniofacial skeletal relationships. In the middle and posterior cranial base, transverse measurements reveal significant sexual dimorphism.