Abstract
Accumulative roll bonding (ARB) and continual annealing and roll-bonding (CAR) processes were used in this study for improving the microstructure and mechanical properties of the A356/10 vol.% SiC metal matrix composite (MMC) produced by semi-solid metal processing (SSM). The results showed that using the ARB and CAR processes led to the following points: (a) the uniformity of the silicon and silicon carbide in the aluminum matrix improved, (b) the Si particles became finer and more spheroidal in appearance, (c) the porosity disappeared, (d) the bonding quality between the reinforcement and the matrix improved, (e) the particle-free zone disappeared, and therefore (f) the tensile strength (TS), elongation, and formability index of the MMC samples improved. However, it was found that the CAR process is a better method for improvement of microstructure and mechanical properties of as-cast MMC compared to ARB process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
