Comparison of the effects of three drying methods on lignin properties

Abstract

In the last few years, a serious effort has been initiated to develop standard methods for lignin characterization at the national and international levels. Thus, several Canadian and ISO standards were recently developed. The current results were generated in an effort to assist the ISO/TC6 Committee come up with a reliable standard method for the measurement of the dry solids content of lignins. In particular, this work investigated the drying of lignin using three different drying methods: conduction oven drying (105 °C), vacuum oven drying at (60 °C), and freeze drying. Ten different lignins were used in this study including wet and air-dried softwood and hardwood kraft lignins in the acid and base forms from the industrial LignoForce™ process and hydrolysis lignin from the TMP-Bio™ process. The results showed that 7 h, 48 h and 24 h were sufficient to reach a constant solids content in the case of all lignins when oven drying, vacuum oven drying under negative pressure (150 mbar), and freeze drying (25 mT) were used, respectively.Kraft lignins in the base form showed higher sensitivity to degradation compared to lignins in the acid form. The total hydroxyl group content of air-dried and wet hardwood lignins in the base form decreased by more than 50 % after vacuum oven-drying for 71.5 h or oven-drying for 16 h compared to freeze-drying for 68 h. The decrease in the total hydroxyl groups was more pronounced (70 %) when the wet softwood lignin in the base form was dried in the oven compared to freeze drying for 68 h.