Abstract
We have reported that the application of ultrasonic scalers on the Er:YAG laser-irradiated enamel surface achieved bond strengths of approximately 16 MPa. However, it is reported that a bond strength of 20 MPa is needed to prevent the marginal gaps, so the tensile bond strength (TBS) of composite resin to the Er:YAG laser-irradiated enamel is still insufficient. Various methods (phosphoric acid etching, air scaling, ultrasonic scaling, air powder polishing, combination with phosphoric acid etching, and prior mechanical removal methods) were tested as a technique to increase TBS of composite resins to the Er:YAG irradiated enamel. Both the methods of mechanical removal following Er:YAG laser irradiation and the phosphoric acid etching following irradiation and mechanical removal had significant effects on TBS. TBS in the group with acid etching following air powder polishing showed highest value, 22.0 MPa. The application of phosphoric acid etching following mechanical removal of Er:YAG laser irradiation was effective to achieve high bond strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.