Abstract
This paper investigates the capabilities and limitations of the EMTP and the NETOMAC program as applied to HVDC system simulation. The fundamental differences between the two programs and their effect on simulation results are described. Consistency of the results obtained from these programs is examined through simulation of a test HVDC network. As expected, a very high degree of agreement between the two sets of simulation results proved to be achievable, but only when particular care was taken to overcome internal program differences. Finally, the new advanced stability feature of NETOMAC is briefly discussed and then tested against the complex transient models established in the EMTP and in the NETOMAC transients program section.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">></ETX>
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
