Comparison of the air-blown bubbling fluidized bed gasification of wood and wood–PET pellets

Abstract

Air-blown bubbling fluidized bed gasification of wood pellets and wood–PET (polyethylene terephthalate) pellets was conducted at 725°C, 800°C, and 875°C. Gasification of mixtures of wood and PET pellets was attempted; however, rapid formation of coke above the fluidized bed prevented steady state operation of the gasifier. Coking was prevented when wood and PET were formed into composite wood–PET pellets. The performance of wood pellets was better than wood–PET pellets. Tar concentrations were lower, while, heating values, thermal outputs, and efficiencies tended to be higher for wood pellets than wood–PET pellets. The addition of secondary air above the fluidized bed was explored as a means of reducing the tar content of the produced gases. The influence of the produced gas tar concentrations on down-stream tar removal units was considered.