Comparison of Staple, Anchor, and Tenodesis Screw for Posterior Tibialis Tendon Fixation: A Biomechanical Analysis

Abstract

Various posterior tibialis tendon fixation techniques are described in literature. Suture anchor, staple and tenodesis screws are widely used for posterior tibialis tendon transfer, but their stiffness and the maximal ultimate failure load were not tested before. We aimed to compare the initial ultimate failure load and stiffnesses of suture anchor, staple and tenodesis screws on bovine tendon fixation to bovine metaphyseal bone. Thirty-five fresh bovine ankle joints and hooves were obtained from a local abattoir. Metatarsals bones with long extensor tendons were harvested. Staple group had 15, suture anchor group had 10, and tenodesis screw group had 10 samples. All fixations were tested with Instron® ElectroPuls® E10000 Test Instrument. Ultimate failure load and failure location were noted. Staple group's median ultimate failure load was 210.03 N (IQR: 133.43), suture anchor group's was 124.33 N (IQR: 63.67), and tenodesis screw group's was 394.46 N (IQR:115.09). Median stiffness of the staple group was 19.87 N/m (IQR: 15.29); the tenodesis screw group's was 20.28 N/m (IQR: 6.18), the anchor group's was 8.54 N/m (IQR: 4.35). Staples' failure occurred on tendon-staple interface, while suture anchors' occurred on anchor-suture interface and tenodesis screws' occurred on tendon-suture interface. Tenodesis screws' ultimate failure load was the highest (tenodesis vs anchor and staple p < .001 and p=.032, respectively). Staple fixation is less expensive than the other methods and can provide sufficient fixation strength but was weaker than the tenodesis screw fixation. Staples are still a good choice for tendon to bone fixation, whereas the suture anchors provide lower fixation strength at a higher cost.