Abstract

Granulation of nanostructured 3 mol% yttria stabilised zirconia using spray freeze drying was investigated to achieve flowable and crushable granules for subsequent die pressing. Commercial nanosuspension consisting of ∼16 nm particles was concentrated to ∼55 wt% solids content via a patented technique, followed by spraying into liquid nitrogen using either a vibrating ultrasonic probe or a twin-fluid atomizer and freeze dried to yield spherical granules. Control of the granule size fractions was investigated by changing the amplitude and the feeding rate of the nanosuspension during ultrasonication, whilst the flow rate of compressed air used for spraying was varied during twin-fluid atomisation. Granules retaining good crushability for pressing were in a size range of 125–250 μm, which were achieved with ∼60 wt% yields using the atomisation route, whilst a maximum of 35 wt% of granules in this size range were produced in previous research using ultrasonication.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.