Comparison of soil solution chemistry sampled by centrifugation, two types of suction lysimeters and zero-tension lysimeters

Abstract

The choice of sampling method for soil solution is of great importance. In this paper soil solution chemistry sampled by centrifugation, two types of suction lysimeters and zero-tension lysimeters have been studied with the purpose of investigating systematic differences between them. The samples were taken at 4 depths from an acidified forest soil as well as from adjacent lime and ash treated soils. A centrifugation drainage method was compared with two types of suction lysimeters (‘Rhizon’ and ‘Prenart’) and zero-tension lysimeters. About half of the 27 variables measured showed a significant difference between the sampling methods used. Typically the centrifuged samples had lower pH (4.0 vs. 4.4), Ca (21 μM vs. 30 μM) and Mg (25 μM vs. 34 μM) concentrations and higher Cl (330 μM vs. 230 μM) and DOC (4.4 mM vs. 3.2 mM) concentrations than the Rhizon lysimeters. Also the other lysimeters showed significant differences compared to the centrifuged samples for about half the number of analytes. Centrifuged samples had higher concentrations of all analytes except NO 3 and PO 4 compared to zero-tension lysimeters and also for all analytes except NO 3 and Al compared to Prenart lysimeters. Among the environmental factors considered depth showed an influence to some extent, while sampling occasion had a great significant impact on the difference between the centrifugation method and the Rhizon lysimeters. Factors like individual pits or soil treatment did not show any influence on the difference between the methods.