Comparison of settling of occlusion in modified and full coverage thermoplastic retainers using T-scan

Abstract

Objectives: The main intent of the study was to evaluate and compare the occlusal bite forces after settling between conventional and modified thermoplastic retainer groups using T-Scan. Material and Methods: This study comprised a total of 20 patients, who approached the retention phase after completion of fixed orthodontic therapy. After debonding (T0), occlusal analysis using the T-Scan system was done at centric occlusion. Group I (control) – 10 patients received the conventional thermoplastic retainer and Group II (experimental) – 10 patients received the modified thermoplastic retainer. Patients were instructed to wear the retainer continuously for 6 months except while eating and brushing. T-scan analysis after 6 months (T6) was done to evaluate the changes in occlusal bite forces. The obtained data were evaluated using STATA/IC software version 16.1 at a predetermined probability value of 0.05 which was considered significant. Results: The result obtained from this study was suggestive of significant improvement in bite force levels at centric occlusion in the modified thermoplastic group compared with the conventional group. Comparing the right (P < 0.17) and left (P < 0.01) posterior region, there was significant increase on the left side. A significant increase at maximum centric occlusion (P < 0.01) was seen in the region of the first molars. The anterior region did not show any improvement (P < 0.62) after 6 months of retention. Conclusion: Partial coverage of thermoplastic retainer significantly improves the occlusal contacts and force levels. The maximum change was seen in the posterior region and the minimum change in the anterior region at centric occlusion.