Comparison of sensitivity between blood parameters and a genotoxic biomarker at low blood Pb levels: A population-based study

Abstract

BackgroundPrevious studies reported that lead (Pb) exposure induced adverse health effects at high exposure concentrations, however, there have been limited data on sensitivity comparisons among different health outcomes at low blood Pb levels. ObjectivesTo compare sensitivity between blood parameters and a genotoxic biomarker among workers exposed to low blood Pb levels (< 20 µg/dl), and to estimate a benchmark dose (BMD). MethodsPb-exposed workers were recruited from a lead-acid storage battery plant. Their blood lead levels (BLLs) were measured. Blood parameters and micronuclei (MN) frequencies were determined. Multivariate linear or Poisson regression was used to analyze relationships between blood parameters or MN frequencies with BLLs. Two BMD software were used to calculate BMD and its 95 % lower confidence limit (BMDL) for BLLs. ResultsThe median BLL for 611 workers was 10.44 µg/dl with the 25th and 75th percentile being 7.37 and 14.62 µg/dl among all participants. There were significantly negative correlations between blood parameters and BLLs. However, MN frequencies correlated positively with BLLs (all P<0.05). Results from the two BMD software revealed that the dichotomous model was superior to the continuous model, and the BMDL for BLL derived from red blood cell (RBC) was 15.11 µg/dl, from hemoglobin (HGB) was 8.50 µg/dl, from mean corpuscular hemoglobin (MCH) was 7.87 µg/dl, from mean corpuscular hemoglobin concentration (MCHC) was 3.98 µg/dl, from mean corpuscular volume (MCV) was 11.44 µg/dl, and from hematocrit (HCT) was 6.65 µg/dl. The conservative BMDL obtained from the MN data was 7.52 µg/dl. ConclusionOur study shows that low dose Pb exposure caused decrease of blood parameters and increase of MN frequencies. The genotoxic biomarker was more sensitive than most blood parameters. BMDLs for BLL derived from MN frequencies and the red blood cell indicators should be considered as new occupational exposure limits. Our results suggest that MN assay can be considered as a part of occupational health examination items.