Comparison of Residual Stress Measured by Diffraction Method and Matrix Etching Method in SiC Fiber Reinforced Titanium Matrix Composites

Abstract

Measurement and modeling of residual stresses in SiC fiber reinforced titanium matrix composites (SiCf/Ti) are still a challenge. Diffraction method and matrix etching method can characterize the strains of matrix and fiber, respectively. A In this work, SiCf/Ti samples with perpendicular and parallel cross-sections to the fibers have been fabricated, and the residual stresses were measured by X-ray diffraction and matrix etching. The results showed that the axial matrix stress in sample with perpendicular cross-sections to the fibers was larger than that in sample with parallel cross-sections to the fibers, while the axial matrix stress calculated from etching was consistent with that from X-ray diffractions based on triaxle stress model, confirming the reliability of triaxle stress model.