Comparison of quasisteady‐state performance of the DEAMOX process under intermittent and continuous feeding and different nitrogen loading rates

Abstract

The recently developed denitrifying ammonium oxidation (DEAMOX) process combines the anammox reaction with autotrophic denitrifying conditions using sulfide as an electron donor for the production of nitrite from nitrate within an anaerobic biofilm. This paper compares a quasisteady-state performance of this process for treatment of baker's yeast wastewater under intermittent and continuous feeding and increasing nitrogen loading rate (NLR) from 300 till 858 mg N/L/d. The average total nitrogen removal slightly decreased on increasing the NLR: from 86 to 79% (intermittent feeding) and from 87 to 84% (continuous feeding). The better performance under continuous feeding was due to a more complete nitrate removal in the former case whereas the ammonia removal was similar for both feeding regimes under the comparable NLR. A possible explanation can be that, during continuous feeding (simultaneous supply of nitrate and sulfide), there were less mass transfer limitations for sulfide oxidizing denitrifiers presumably located in the outer layer of sludge aggregates. On the contrary, the ammonia oxidisers presumably located inside the aggregates apparently suffered from nitrite mass transfer limitations under both the feedings. The paper further describes some characteristics of the DEAMOX sludge.