Comparison of quantification of selenocyanate and thiocyanate in cultured mammalian cells between HPLC-fluorescence detector and HPLC-inductively coupled plasma mass spectrometer

Abstract

The simultaneous detection of cyanide (CN), thiocyanate (SCN), and selenocyanate (SeCN) by a HPLC-fluorescence detector (FLD) with the post-column König reaction was recently reported. SCN and SeCN are also detectable by HPLC-inductively coupled plasma mass spectrometry (HPLC-ICP-MS) because sulfur and selenium can be detected, respectively, without any pre- or post-treatment. ICP-MS has high sensitivity for selenium and sulfur detection and is robust to sample matrices. In this study, we compared HPLC-FLD with the post-column König reaction and HPLC-ICP-MS in terms of SCN and SeCN detection sensitivity and linearity. The limit of detection (LOD) for SCN indicated that HPLC-FLD with the post-column König reaction was 354 times more sensitive than HPLC-ICP-MS. Likewise, the LOD for SeCN indicated that HPLC-FLD was 51 times more sensitive than HPLC-ICP-MS. These results demonstrated that HPLC-FLD was a more suitable technique for SeCN and SCN detection than HPLC-ICP-MS. We previously reported that SeCN was generated in selenite-exposed mammalian cells to detoxify excess selenite. HPLC-FLD with the post-column König reaction enabled good separation and detection for quantifying SCN and SeCN in mammalian cell lines exposed to selenite. The intracellular SCN and SeCN concentrations determined by this technique suggested differences in the metabolic capacity for selenite to form SeCN among the cell lines. In addition, since the amount of intracellular SCN and SeCN were significantly decreased by pretreatment of myeloperoxidase (MPO) inhibitors, SCN and SeCN were resulted from the interaction of sulfur and selenium with endogenous CN, respectively, generated with MPO.