Comparison of polycrystalline and epitaxial Cu(In, Ga)Se2 solar cells with conversion efficiencies of more than 21%

Abstract

Polycrystalline Cu(In,Ga)Se2 (CIGS) solar cells are widely studied for their application in thin-film photovoltaics, but analysis of their crystalline properties is difficult owing to the presence of grain boundaries and defects. Epitaxial CIGS (epi-CIGS) solar cells can potentially address the issues of polycrystalline CIGS (poly-CIGS) solar cells, but their conversion efficiency has not been widely studied. We fabricated epi-CIGS layers using techniques developed for high-efficiency ploy-CIGS solar cells such as Ga grading, Na doping, and heat-light soaking. Here, scanning transmission electron microscopy and secondary ion mass spectrometry were used to compare the structural characteristics of poly- and epi-CIGS solar cells with conversion efficiencies of more than 21%. Both types of solar cells had similar Ga gradient profiles, and abrupt interfaces were observed between the CIGS and Mo, CIGS and GaAs, and CdS and CIGS layers. The poly-CIGS layer had a higher Na concentration than the epi-CIGS layer because the grain boundaries of the former included high concentrations of Na ions. Meanwhile, the Na ions in the epi-CIGS layer promoted the interdiffusion of In and Ga. For both types of solar cells, heat-light soaking increased the carrier concentration by more than 1 × 1017 cm−3. These observations suggest that grain boundaries are not the main factor limiting the conversion efficiency of poly-CIGS solar cells.