Abstract
ObjectivesThis study evaluated temperature increases in the composite and pulpal side of dentin from incremental and bulk fillings in composite restorations. MethodsClass-1 cavities (5mm×4mm×3mm) were prepared in ten extracted third molars, filled with composite, and restored with two separate horizontal layers of Filtek Z250 (3M ESPE) in the incremental group or a single layer of SureFil SDR Flow (Dentsply) in the bulk-fill group (n=5). After placing the specimens in a 36.5°C water bath, temperatures were measured with eight thermocouples at the bottom center (BC), middle center (MC), top center (TC), bottom corner (BE), middle corner (ME), and top corner (TE) of the cavity, at the pulpal side of the dentin within the pulp chamber (PD), and in the curing light (CL) tip during light curing at 750mW/cm2 for 20s and then analyzed with one-way analysis of variance and Tukey’s HSD tests (α=0.01). ResultsMaximum temperatures ranged from 39.0°C (PD 1st increment) to 60.0°C (MC 1st increment) in the incremental group and from 42.0°C (PD) to 74.9°C (TC) in the bulk-fill group. In the incremental group, temperatures were similar between the 1st and 2nd increments, except at MC and BC. ConclusionsBulk-fill group exhibited a greater increase in temperature during composite restoration. Regardless of the filling technique, more heat was generated at the center than at the corner and at the top than at the bottom of the composite. PD temperatures increased by 3.1°C and 5.5°C in the incremental group and bulk-fill group, respectively. Clinical significanceAlthough bulk fillings save clinical chair time, clinicians should be aware of the greater heat that is generated with increasing amounts of composites during polymerization, which can jeopardize the pulpal health, especially when a large and deep cavity is being restored.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
