Abstract
Objective to study the performance of Zn/Ni composite coatings and Al/Zn composite coatings, which were deposited by Cold Gas Dynamic Spray. Methods: Those coatings was sprayed by Zn and Ni mixture powder and Al and Zn mixture powder on 300M high-strength steel surface, the SEM images and micro hardness tester analyzed the two kinds coatings’ morphology and microstructure. The corrosion resistance of Zn/Ni coatings can be compare with Al/Zn coatings, which was investigated by neutral salt-spray test and coating furcated test. Results The results indicate that Zn/Ni coatings porosity is 0.8%, it is same as Al/Zn coatings. The micro hardness of Zn/Ni coatings is 70.8HV, which is higher than Al/Zn coatings 61.2HV. However, the salt spray result of Al/Zn coatings can reach 1000h and it can reach 770h even the coatings fails; which is better than Zn/Ni coatings, their salt spray resistance can reach 770h and it can reach 350h when the coatings fails. Conclusion those coatings could both be efficient corrosion resistance coatings on 300M high strength steel surfaces.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Earth and Environmental Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
