Comparison of mechanical and molecular measures of mobility during constant strain rate deformation of a PMMA glass

Abstract

ABSTRACTWe performed constant strain rate deformation and stress relaxation on a poly(methyl methacrylate) glass at Tg – 19 K, utilizing three strain rates and initiating the stress relaxation over a large range of strain values. Following previous workers, we interpret the initial rate of decay of the stress during the relaxation experiment as a purely mechanical measure of mobility for the system. In our experiments, the mechanical mobility obtained in this manner changes by less than a factor of 3 prior to yield. During these mechanical experiments, we also performed an optical measurement of segmental mobility based on the reorientation of a molecular probe; we observe that the probe mobility increases up to a factor of 100 prior to yield. In the post‐yield regime, in contrast, the mobilities determined mechanically and by probe reorientation are quite similar and show a similar dependence on the strain rate. Dynamic heterogeneity is found to initially decrease during constant strain rate deformation and then remain constant in the post‐yield regime. These combined observations of mechanical mobility, probe mobility, and dynamic heterogeneity present a challenge for theoretical modeling of polymer glass deformation. © 2016 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2016, 54, 1957–1967