Comparison of Maximum Heat Generation during Implant Site Preparation between Single and Gradual Drilling Protocols in Artificial D1 Bone Blocks: An In Vitro Study.

Abstract

Aim Two protocols for implant site preparation have been demonstrated in the literature: conventional gradual drilling and single drilling. Objectives The purpose of this study is to assess the maximum temperature changes reached during and after implant site preparation of 4.2 implant diameter using the gradual drilling protocol and single drilling protocol. Material and Methods. The artificial bone block samples (#1522–23; Sawbones, Malmö, Sweden) with the density of d1 were divided into two groups. Twelve implant site preparations were performed with the use of only one drill in group A, and the same number of preparations was performed using five gradual drills in group B. The drilling speed was set for each group at 1500 rpm with the use of external irrigation with a constant of 50 ml/min at room temperature (25 ± 1°C). The maximum temperature changes were measured using an infrared camera (Fluke Ti55, USA). The data were gathered and analyzed using Student's t-test for independent samples. Results With the 95% confidence intervals (CIs) for the means of ∆T between groups A and B, group B showed a statistically significant higher temperature change (∆T) than group A. Conclusions The current outcomes propose that the single drilling protocol, while preparing a bed for a 4.25 mm dental implant in d1 artificial bone blocks, generates less heat than the conventional gradual drilling protocol.