Abstract

BackgroundMicroalgae are a potential source of sustainable commodities of fuels, chemicals and food and feed additives. The current high production costs, as a result of the low areal productivities, limit the application of microalgae in industry. A first step is determining how the different production system designs relate to each other under identical climate conditions. The productivity and photosynthetic efficiency of Nannochloropsis sp. CCAP 211/78 cultivated in four different outdoor continuously operated pilot-scale photobioreactors under the same climatological conditions were compared. The optimal dilution rate was determined for each photobioreactor by operation of the different photobioreactors at different dilution rates.ResultsIn vertical photobioreactors, higher areal productivities and photosynthetic efficiencies, 19–24 g m−2 day−1 and 2.4–4.2 %, respectively, were found in comparison to the horizontal systems; 12–15 g m−2 day−1 and 1.5–1.8 %. The higher ground areal productivity in the vertical systems could be explained by light dilution in combination with a higher light capture. In the raceway pond low productivities were obtained, due to the long optical path in this system. Areal productivities in all systems increased with increasing photon flux densities up to a photon flux density of 30 mol m−2 day−1. Photosynthetic efficiencies remained constant in all systems with increasing photon flux densities. The highest photosynthetic efficiencies obtained were; 4.2 % for the vertical tubular photobioreactor, 3.8 % for the flat panel reactor, 1.8 % for the horizontal tubular reactor, and 1.5 % for the open raceway pond.ConclusionsVertical photobioreactors resulted in higher areal productivities than horizontal photobioreactors because of the lower incident photon flux densities on the reactor surface. The flat panel photobioreactor resulted, among the vertical photobioreactors studied, in the highest average photosynthetic efficiency, areal and volumetric productivities due to the short optical path. Photobioreactor light interception should be further optimized to maximize ground areal productivity and photosynthetic efficiency.

Highlights

  • Microalgae are a potential source of sustainable commodities of fuels, chemicals and food and feed additives

  • Areal productivity and photosynthetic efficiency of four different outdoor photobioreactors operated at different dilution rates were determined

  • The horizontal tubular photobioreactor, vertical tubular photobioreactor, open raceway pond and flat panel were in operation for 111, 102, 42 and 77 days, respectively

Read more

Summary

Introduction

Microalgae are a potential source of sustainable commodities of fuels, chemicals and food and feed additives. The current high production costs, as a result of the low areal productivities, limit the application of microalgae in industry. Results: In vertical photobioreactors, higher areal productivities and photosynthetic efficiencies, 19–24 g m−2 day−1 and 2.4–4.2 %, respectively, were found in comparison to the horizontal systems; 12–15 g m−2 day−1 and 1.5–1.8 %. The highest photosynthetic efficiencies obtained were; 4.2 % for the vertical tubular photobioreactor, 3.8 % for the flat panel reactor, 1.8 % for the horizontal tubular reactor, and 1.5 % for the open raceway pond. Microalgae are produced in a wide variety of cultivation systems including open raceway ponds, tubular, and flat panel photobioreactors. The open raceway pond is currently the mostly used and cheapest cultivation system for commercial production of microalgae [4]. Norsker de Vree et al Biotechnol Biofuels (2015) 8:215 et al estimated an investment cost of 0.37 M€/ha for a 100 ha scale open raceway pond plant [3]

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call