Comparison of Ferrous Calcium Silicate Slag and Calcium Ferrite Slag Interactions with Magnesia-Chrome Refractories

Abstract

The cost of maintaining and eventually replacing refractories as a result of slag attack is a significant cost component in the copper industry. Converting matte to blister copper takes place in reactors lined with direct-bonded magnesia-chrome refractories, and several continuous converting operations use calcium ferrite slag. Unfortunately, the low viscosity of calcium ferrite slag makes it aggressive toward the refractories. Ferrous calcium silicate (FCS) slag has been proposed as a replacement; however, the effect of this slag on magnesia-chrome refractories has not been studied. In this work, the interactions between FCS slag and magnesia-chrome refractory at 1573 K (1300 °C) with an oxygen partial pressure of 10−6 atm were studied and compared with that experienced with calcium ferrite slag under the same conditions. Both slags penetrated the pores in the refractory and caused compositional change in the chromite spinel intergranular bonding phase through cation interdiffusion, which resulted in cracking and debonding of periclase grains. It was observed that the refractory was penetrated much more deeply by calcium ferrite slag than FCS slag because of the higher surface tension and lower viscosity of calcium ferrite slag. As a result, the refractory was attacked less by FCS slag than it was by calcium ferrite slag. It is concluded that the use of FCS slag in continuous copper converting is likely to extend refractory life.