Comparison of fatigue test results of high-strength steel DED-Arc specimens with milled and unmilled surfaces

Abstract

The surface characteristics of direct energy deposition (DED)-Arc specimens have been previously explored, revealing the dual effect of the surface topography on fatigue strength. This effect includes a reduction in the nominal load-bearing cross-section due to the waviness of the surface and the initiation of fatigue cracks at combined geometric and metallurgical notches from the surface. To complement these findings, this study focuses on the fatigue life and crack initiation of milled DED-Arc samples, e.g., after removal of the geometric notches. Fatigue tests on DED-Arc specimens validate the impact of surface topography on fatigue strength, emphasizing the significance of surface characteristics in determining structural integrity. The additional tests conducted on milled surfaces provide insights into the failure mechanisms specific to these samples. Fracture surface analysis, microstructure characterization, and hardness measurements are performed. For both surface conditions, cracks originate in the interlayer zone, where local hardness is reduced. In unmilled specimens, this is due to the stress concentration effect, and in milled samples, this is due to softened interlayer zones. The fatigue life of milled specimens is comparatively high, demonstrating the importance of optimizing surface characteristics for improved fatigue resistance.Highlights1. Both, unmilled and milled specimens, show crack origins in the interlayer areas. For unmilled specimens, this is because of the local stress concentration in the notch; for milled specimens, it was shown that soft zones between the layers act as the weakest link.2. The fatigue strength of unmilled test coupons is significantly lower than those of milled specimens.3. Unmilled samples exhibit multiple crack origins.