Abstract

BackgroundCone beam computerized tomography (CBCT) has been widely used in dental implanting. However, the local hospitals usually don’t have access to CBCT due to the cost and medical investment, especially in West of China. The doctors in local hospitals have to make reasonable dental planting using orthopantomography (OPG) to reduce risks. Therefore, it is clinically meaningful to determine the magnification rate of OPG to obtain correct diagnosis. This study investigated the magnification rate of OPG in measuring different maxillofacial loci compared with CBCT.MethodsEighty-six patients demanding dental implanting were scanned by CBCT and OPG. The vertical distance between the alveolar ridge crest of the maxillary first molar and the sinus bottom of the upper jaw, the distance between the alveolar ridge crest of the mandibular first molars and the top of nerviduct in the mandibular alveolar, and the distance between the alveolar ridge crest of the maxillary central incisors and the bottoms of the nasal cavities were measured. The horizontal distance in those loci were also measured. The distances derived from CBCT were used as reference. The distances between the two methods were compared using paired t-test. The magnification rates at these positions were calculated. The relationship between the data acquired from the two methods was analyzed Pearson correlation.ResultsThe correlation coefficients (R) between the paired samples obtained from OPG and CBCT were highly related (P < 0.05) with R values varying from 0.840 and 0.959 in vertical distances and R values varying from 0.703 and 0.904 in horizontal distances. Compared with data obtained from CBCT, the mean vertical magnification rates were 11.38% and 12.95% vertically and 8.55% and 9.43% horizontally for the first molars in the right and left maxilla respectively; 7.26% and 6.35% vertically and 5.33% and 4.96% horizontally for the first molars in the right and left mandible respectively; and 5.55% and 4.84% vertically and 6.53% and 7.47% horizontally for the central incisors in the upper right and left jaws respectively.ConclusionThe magnification rates of OPG at these teeth are different. The distances measured by OPG were highly correlated with that measured by CBCT.

Highlights

  • Cone beam computerized tomography (CBCT) has been widely used in dental implanting

  • The correlation coefficients (R) between the paired samples obtained from OPG and CBCT were highly related (P < 0.05) with R values varying from 0.840 and 0.959 in vertical distances at different teeth and R values varying from 0.703 and 0.904 in horizontal distances (Table 1)

  • The present study showed different magnification rates of OPG compared with CBCT in measuring different maxillofacial loci

Read more

Summary

Introduction

Cone beam computerized tomography (CBCT) has been widely used in dental implanting. Panoramic radiography and periapical radiography are important methods in dental implant planning [1, 2]. These two-dimensional radiographs can be affected by tissue superimposition due to malocclusion deformity or other complex situations. Orthopantomography (OPG) is an important imaging method to assess vertical bone volume and detect dental caries and periodontal diseases [3]. Maxillofacial cone beam computed tomography (CBCT) has been widely used in dental implanting [7, 8], assessment of orthodontic treatment, complex alveolar surgery, oral local system reconstruction and treatment of tooth and dental pulp diseases. CBCT is advantageous in high spatial resolution, short scan time and rapid image acquisition [9,10,11,12,13]

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call