Abstract
Introduction: Heat-cured acrylic resin is the most often used material in the manufacture of denture base. Along with the development of science and technology, to overcome the shortcomings of heat-cured acrylic resin, repairment of denture base material was done, one of them is a thermoplastic nylon resin. On the use of denture often found Candida albicans attached to the denture. This study aimed to determine the comparison of the amount of Candida albicans colony on heat-cured acrylic and thermoplastic nylon resin after immersed in the Ulee Kareng coffee (Coffea robusta). Methods: The number of specimens in this study were 8 specimens; 4 Meliodent® heat-cured acrylic resins and 4 Bio Tone® thermoplastic nylon resins with size of 10x10x2 mm. The methods of this study was experimental laboratory. The specimens were stored in a solution of Ulee Kareng coffee (Coffea robusta) for 7 days. Each specimen was contaminated with Candida albicans, then the number of Candida albicans colony was counted with Colony counter, from threshing results of heat-cured acrylic and thermoplastic nylon resins. Data were analyzed with unpaired t test. Results: Unpaired t test results showed that there were significant differences (p<0.05) between the number of colonies of Candida albicans in heat-cured acrylic resin (4.5 CFU/ml) and thermoplastic nylon resin (1.5 CFU/ml) after both immersed in the Ulee Kareng coffee (Coffea robusta). Conclusion: The amount of Candida albicans colony on heat-cured acrylic resin was higher than on thermoplastic nylon resin.
Highlights
Heat-cured acrylic resin is the most often used material in the manufacture of denture base
The brewing of Ulee Kareng coffee (Coffea robusta) was conducted at the Laboratory of Biology Faculty of Educational Science Syiah Kuala University, and the counting of Candida albicans colony amount was conducted at the Laboratory of Microbiology, Faculty of Veterinary Medicine Syiah Kuala University
Samples of this study were ATCC 10231 Candida albicans, and the test material used was the specimens of Meliodent® heat-cured acrylic resin and Bio Tone® thermoplastic nylon resin
Summary
Heat-cured acrylic resin is the most often used material in the manufacture of denture base. This study aimed to determine the comparison of the amount of Candida albicans colony on heat-cured acrylic and thermoplastic nylon resin after immersed in the Ulee Kareng coffee (Coffea robusta). Results: Unpaired t test results showed that there were significant differences (p
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have