Abstract
We have increased the figure-of-merit (FOM) of a (Ba,Sr)TiO₃ (BST) film microwave tunable device by approximately three times for MgO(111) compared with a MgO(100) substrate at a frequency range of 20 GHz. Differences in permittivity and tunability in a BST film may be closely related to the difference in the film strain. The ratio of calculated permittivities of BST(100) and BST(111) films nearly corresponds to that of the FOM in the microwave range, which was rather unexpected because a higher permittivity leads to both larger tunability and dielectric loss in ferroelectrics. From a series of results, it is suggested that there are additional influences of orientation (other than the direct influence of strain itself) on the tunable properties in BST films especially in the high-frequency region.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
