Abstract
A direct comparison of aqueous and non‐aqueous tape casting was investigated. Aqueous and non‐aqueous formulations were developed for tape casting of aluminum nitride (AlN) powder. The oxygen content of the AlN powder in aqueous ball‐milling media had a slight increase, but it did not almost influence the thermal conductivity of AlN substrate. The solid loading of aqueous AlN slurry was higher than that of the non‐aqueous one, but its viscosity was lower than that of non‐aqueous AlN slurry. Under the same burnout program, the residual carbon content in aqueous AlN green sheet was lower than that of the non‐aqueous one. The thermal conductivity of the aqueous AlN substrate sintered at 1850°C for 3 h was 138 W·(m·K)−1, which was close to 142 W·(m·K)−1 of the non‐aqueous AlN substrate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
