Abstract
The aim of the article is to verify dimensions of the hydraulic arm column (the necessary cross-sectional area) by analytical dimensional calculation and thus to design a lifting rotary arm which will be located on the pick-up car body (Figure 1). After the analysis of dimensions, the next step is creation of the structure in FEM program and then a numerical analysis will be carried out for verification of stress in the structure already with the values that are not available for the preliminary design (e.g. the structure weight). The next step in the solution will be to import the proposed and by strength calculations checked geometry into the multibody system program, where the dynamic response of the structure will be monitored, depending on the size of the load and the movement possibilities of this mechanism.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
