Comparison of active and passive vibration control techniques for electric drive power electronic subsystem: Experimental validation

Abstract

Reducing vibration and noise from power electronics components is vital for enhancing the performance and acceptance of electric vehicles, emphasizing the need for effective mitigation strategies in sustainable transportation. This paper compares passive and active vibration techniques, with a specific focus on utilizing particle damping for passive vibration control. The method achieves vibration reduction through viscoelastic deformation and friction resulting from the movement and collisions of granular material within the cavity. This contribution outlines diverse design strategies for integrating particle dampers into power electronic components. The active control approach, operating typically in the 50 Hz to 1200 Hz frequency range, can concurrently support passive noise treatments. Piezoelectric ceramics serve as both actuators and sensors in active noise reduction. Following the identification of dominant mode shapes, appropriate actuator and sensor positions are chosen. The control problem of the smart system is then addressed, opting for a velocity feedback control algorithm in a real collocated design. This algorithm computes input signals for actuators bonded to the outer surface, achieving significant active damping effects. Lab-tested techniques are validated in real-world conditions with a full-scale electric-drive toolkit, affirming their efficacy in reducing vibration and noise and underscoring their potential for implementation in electric vehicles.