Abstract
The shape of concrete aggregate fine particles (fines), with particle sizes between 3μm and 250μm, produced by high-speed vertical shaft impact (VSI) crushing of 10 different rock types from quarries in Norway, has been studied by both dynamic image analysis (DIA), which is a two-dimensional (2-D) method, and X-ray computed microtomography (μCT) coupled with spherical harmonic (SH) analysis, which is a three-dimensional (3-D) method. The 3-D μCT results serve as a check on the 2-D DIA results. The intent was to evaluate the applicability of the 2-D DIA method to extract shape parameters that could represent the actual 3-D shape of the VSI crushed concrete aggregate particles. The results show that the 2-D DIA method has problems correctly measuring the shape of particles smaller than about 40μm due to too large of a pixel size and possibly some particle flocculation. The findings of this paper show, however, that if a large enough number of particles are analysed by the 2-D DIA method, a good but limited indication of the actual 3-D shape of the irregular crushed aggregate fines larger than 40μm can be acquired and used for simple quality control in hard rock quarries.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.