Comparison between the surface defects caused by Al2O3 and TiN inclusions in interstitial-free steel auto sheets

Abstract

Al2O3 and TiN inclusions in interstitial-free (IF) steel deteriorate the properties of the steel. To decrease the defects of cold-rolled sheet, it is important to clearly distinguish between the degrees of damage caused by these two inclusions on the surface quality of the steel. In this study, a nanoindenter was used to test the mechanical properties of the inclusions, and the distribution and size of the inclusions were obtained by scanning electron microscopy (SEM). It was found that when only mechanical properties are considered, TiN inclusions are more likely to cause defects than Al2O3 inclusions of the same size during the rolling process. However, Al2O3 inclusions are generally more inclined to cause defects in the rolling process than TiN inclusions because of their distribution characteristic in the thickness direction. The precipitation of Al2O3 and TiN was obtained through thermodynamical calculations. The growth laws of inclusions at different cooling rates were calculated by solidification and segregation models. The results show that the precipitation regularity is closely related to the distribution law of the inclusions in IF slabs along the thickness direction.