Comparison between the adsorption properties of Pd(111) and PdCu(111) surfaces for carbon monoxide and hydrogen

Abstract

Thermal desorption spectroscopy and LEED have been used to investigate the interaction of CO and hydrogen with a Pd 0.75Cu 0.25(111) single crystal surface with surface composition of about Pd 0.7Cu 0.3. The main objective was to make a comparison with the previously studied Pd 0.67Ag 0.33(111) (surface composition Pd 0.1Ag 0.9) and Pd(111) surfaces. In addition, the effect of preadsorbed H on subsequent CO dosage and the effect of adsorbed CO on postdosed hydrogen are described. Marked differences were found in the adsorption behaviour of the three surfaces towards CO and hydrogen. The maximum amount of H and CO that can be adsorbed at 250 K and pressures below 10 −9 mbar is much lower on the PdCu surface than expected on the basis of the surface composition. This effect appears to be caused by a low heat of adsorption of hydrogen and CO and Pd singlet sites. Arguments are presented that singlet Pd sites or isolated Pd atoms in a Cu or Ag matrix are able to trap and dissociate the hydrogen molecule at 250 K. The CO desorption spectra are not influenced by pre- or postexposed hydrogen. Adsorbed CO hampers the uptake of hydrogen upon subsequent exposure to hydrogen. Postdosed CO causes adsorbed H adatoms to move to the bulk (adsorbed H). CO exposure at 250 K results in a very broad desorption plateau between 310 and 425 K with hardly discernable maxima. The results can be explained in terms of the size and relative concentration of the various Pd sites present on the surface (triplet, doublet and singlet sites). It can be concluded that for Pd (111) the heat of adsorption of both CO and H differ appreciably for the triplet, doublet and singlet sites. The effect of site has a larger contribution to the decrease of the heat of adsorption with coverage than the effect of lateral interaction in the adlayer. For Pd(111), PdCu(111) and PdAg(111) the effect of the available Pd sites is the major effect that determines the heat of adsorption, followed by the effect of lateral interaction and for the alloy surfaces the electronic or ligand effect.