Abstract

BackgroundPostoperative assessment of pulmonary function is important for estimating the risk of thoracic surgery and long-term disability following pulmonary resection, including predicted postoperative (ppo) forced expiratory volume (FEV) in one second (ppoFEV1) and percent predicted lung diffusion capacity for carbon monoxide (ppo%DLCO) estimation. The ppo values were compared using four different estimation methods between chronic obstructive pulmonary disease (COPD) and non-COPD patients and according to the resected lobe.MethodsThis prospective study included 59 eligible patients requiring single lobectomy and succeeded in performing pulmonary function tests at 3 and 12 months after lobectomy. The ppoFEV1 and ppo%DLCO were compared with poFEV1 and po%DLCO obtained at 3 and 12 months after lobectomy. The ppo values were estimated using the four usual methods: the 19-segment anatomical technique (S), perfusion scintigraphy (Q), quantitative CT (CT), and quantitative CT with low attenuation volume (CTLAV) subtraction.ResultsFor non-COPD and COPD patients, the smallest mean difference between ppo and po values was observed by S for FEV1 and %DLCO. Based on the resected lobe, the smallest mean difference was observed by (I) Q for right upper lobectomy (RUL) excluding %DLCO at 12 months by S, (II) S for left upper lobectomy (LUL), (III) CT and CTLAV for right lower lobectomy (RLL), and (IV) CT and CTLAV for left lower lobectomy (LLL) at 12 months. The ppo values calculated by S for RUL (FEV1 at 3 and 12 months and %DLCO at 3 months) and by all four methods for LLL (FEV1 and %DLCO at 3 months) were smaller than the po values.ConclusionsThe S method is adequate for calculating ppoFEV1 and ppo%DLCO when patients are classified as non-COPD and COPD. However, S sometimes overestimates the ppoFEV1 and ppo%DLCO when patients are classified according to the resected lobe. The CTLAV method may be the method of choice instead of S for calculating ppoFEV1 and ppo%DLCO in patients who undergo lung lobectomy despite the presence or absence of airflow limitation.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.