Abstract
Oxide-reduced copper powder can be produced efficiently at low cost. The volume shrinkage, porosity, maximum pore size, permeability and thermal conductivity of wicks sintered from two oxide-reduced (OR) powders were compared with one from water-atomized (WA) powder. The green specimens were sintered at temperatures from 800 to 1000 °C in a tube furnace under a reduction stream of 10% hydrogen and 90% argon. The results show that the property variations of OR − 100 and WA wicks due to porosity changes have a similar tendency and range. Nine hundred degree celsius is a recommended sintering temperature for producing ideal wicks for use in heat pipes. A smaller maximum pore size can be obtained by increasing the green density.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
