Abstract
The effect of Al, Zn, and Gd respectively on the microstructure and mechanical properties of Mg alloy Mg-Sn-Li (the base alloy) is performed. Our results reveal that with Al addition (Al-modified alloy) or Zn addition (Zn-modified alloy), the secondary dendrite arm spacing of the primary α-Mg phase is refined and no new phase is formed. Gd addition (Gd-modified alloy) results in the formation of needle-like or particle-like GdMgSn phase. The extruded base alloy has a low tension-compression yield asymmetry (about 1.00). Addition of Al or Gd yields a slight increase in value of tension-compression yield asymmetry, while Zn a notable reduce. Under tension along the extrusion direction, the yield strength and ultimate tensile strength of Al-modified and Zn-modified alloy other than Gd-modified alloy are enhanced when compared with the base alloy. This is attributed to solute strengthening, the reduced volume fraction of tin-containing metallic compounds and the existence of many needle-like GdMgSn phases in α-Mg matrix. The yield strength of the Gd-modified alloy under tension is the lowest whereas not under compression. This associates with the fact that GdMgSn phases distributed mainly in the interior of grains would offer resistance to twin propagation and growth.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
