Abstract
ABSTRACTWe studied the pulmonary toxicity of indium hydroxide (In(OH)3), which is produced during a recycling process of indium-tin oxide (ITO), in comparison with that of ITO or indium oxide (In2O3), two raw materials of flat panel displays. One hundred and forty-four male Wistar rats were intratracheally given equivalent doses of 10 mg/kg indium as In(OH)3, ITO, or In2O3 particles, twice a week, for a total of 5 times for 2 weeks. Control rats were given distilled water as a vehicle. After 3 weeks, these rats were serially euthanized, and toxicological effects were determined. Body weight gain was significantly suppressed in the In(OH)3-treated rats compared to that in the control group, but not in the ITO- or In2O3-treated rats. Relative lung weights in all the indium-treated groups significantly increased compared to those in the control group throughout the observation period. Furthermore, lung weights in the In(OH)3 group were significantly higher than those in either the ITO or In2O3 group. Blood indium levels in the In(OH)3-treated rats were much higher, 70- to 200-fold, than those in the In2O3- or ITO-treated rats at each time point. Although the lung indium content decreased gradually during the observation periods, the content in the In(OH)3 group was significantly higher than that in either the ITO or In2O3 group. A histopathological analysis revealed foci indicating a slight to severe pulmonary inflammatory response, including exudation to alveolar spaces, were present in all the indium-treated groups. Interstitial fibrotic proliferation was seen only in the In(OH)3-treated rats. The severity of these lesions in the In(OH)3-treated rats was greater than that in either the ITO- or In2O3-treated rats.The results of our study clearly demonstrated that In(OH)3 particles caused severe pulmonary toxicity when repeated intratracheal instillations were performed in rats. Furthermore, the toxic potency of In(OH)3 in the lung was much higher than that of ITO and In2O3. Accordingly, the toxicity of In(OH)3 particles should be considered in addition to that of ITO and In2O3 particles when indium exposure occurs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.