Abstract
In large-scale water diversion projects, especially in the central and western regions of China, long-distance deep buried tunnels are generally involved. Therefore, it is essential to carry out field tests to obtain the permeability of the rock mass through which tunnels pass. However, the test holes of large-scale water diversion projects are basically located in mountain areas with complex hydrogeological conditions. Meanwhile, the test holes are far apart and large in depth. As a result, traditional pumping tests cannot meet the requirements. Therefore, the slug test was chosen as the main test method, and the calculation results of the water injection test, the water pressure test and the slug test are analyzed and compared. The calculation results of the three test methods are basically consistent. However, the water injection test and the water pressure test are difficult to implement at a large scale due to many environmental constraints, complex test equipment, long test periods and other factors. Furthermore, the Kipp model, the CBP model and the proposed HWS model, considering the effect of the finite thickness well-skin layer for the first time, were used to analyze and process the slug test data, respectively. The curve fitting effect of the Kipp model was the best, but the calculations were generally larger. The difference between the CBP model and the proposed HWS model is smaller in the calculation results; however, the curve fitting effect of the CBP model is the worst, and the CBP model needs to be further improved. The curve fitting effect of the proposed HWS model was between that of the Kipp model and the CBP model, and the proposed HWS model can be applied to the parameter calculations of the slug test with well-skin. In general, with reference to the criteria for the damping coefficient of the aquifer in the Kipp model, the Kipp model was applicable to the slug test for test holes without well-skin and an aquifer damping coefficient between 0.1 and 5.0. The CBP model was applicable to the slug test under the conditions of no well-skin and an aquifer damping coefficient greater than 2.0. The novel proposed HWS model was applicable to the slug test when the aquifer damping coefficient was greater than 1.0 under the conditions of no well-skin, positive well-skin and negative well-skin.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.