Abstract

ABSTRACTThe sorption behavior of Sc(III) on different materials including activated carbon (AC), carbon nanotubes (CNTs), graphene oxide (GO), and the chelating resin Chelex 100 was investigated. In general, the sorption of scandium increases with increasing pH. For pH in the range from 2.5 to 5.5, the sorption of Sc(III) onto CNTs, GO, and Chelex 100 is quantitative, whereas a significantly lower amount of scandium ions was retained on AC. The specific amount of Sc(III) adsorbed at pH 2 attained 2.1, 2.9, 36.5, and 37.9 mg g−1 for AC-COOH, Chelex 100, GO, and CNTs-COOH, respectively. At pH 4, a similar value was obtained for oxidized AC (2.2 mg g−1), whereas the specific amount adsorbed significantly increased for Chelex (23.4 mg g−1). The highest values were obtained for GO (39.7 mg g−1) and oxidized CNTs (42.5 mg g−1). Better kinetic retention was observed at pH 2 for CNTs and GO, whereas at pH 4 the kinetic behavior of Chelex 100, GO, and CNTs toward Sc(III) was comparable.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.