Abstract

AbstractThe direct Fourier transform-spread OFDM (DFT-s-OFDM) and cyclic prefix orthogonal frequency division multiplexing (CP-OFDM) are used for the end-to-end data transmission to support the 5G services and backward compatibility. Improving battery life has always been an important concern in 5G machine-to-machine (M2M) communication nodes. Efficient utilization of power amplifiers (PA) and inferior peak-to-average power ratio (PAPR) is helpful to achieve enhanced battery life. Filter bank multi-carrier (FBMC) multiplexing is an alternative to CP-OFDM that offers low PAPR with the benefits of CP removal. Another way to get low PAPR is single carrier OFDM (SC-FDMA). The transmission requirements between these services are different, which presents a challenge for waveform adaptability to PAPR issues. The DFT-s-OFDM technique is one of the choices to overcome the PAPR that is used in uplink scenarios. Apart from PAPR reduction, DFT-s-OFDM provides optimal use of nonlinear power amplifiers. In addition to PAPR analysis, spectral efficiency is also compared in the simulation results. Using parameters that adjust the cost of spectral efficiency, DFT-s-OFDM provides the extent of improvement in PAPR performance and bit error rate over traditional CP-OFDM, SC-FDMA, and FBMC against the noisy channel.KeywordsM2M5G (NR)PAPRBERSNROFDMCP-OFDMSC-FDMAFBMC DFT-s-OFDM

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.