Comparative study of materials for friction pairs in a new high water-based hydraulic motor with low speed and high pressure

Abstract

PurposeAiming at improving the mechanical efficiency, the applicability and the working life of high water-based hydraulic motor (HWBHM) under working conditions at low speed and high pressure, the friction performance of different matching materials for piston slipper – crankshaft pair with high water-based hydraulic fluid (HWBHF) under working conditions at low speed and high pressure – were studied.Design/methodology/approachThe friction experiments for different materials (316L, 316L with surface coating OVINO – tetrahedral amorphous carbon [TAC; 316L-TAC] – 316L with surface coating OVINO-graphite intercalated compound [GIC; 316L-GIC] and polyetheretherketone [PEEK] reinforced with 30 per cent carbon fiber [PEEK-30CF]) under HWBHF lubrication were implemented on a pin-disk friction abrasion machine to determine the variations of coefficient of friction (CoF) and wear rate for each matching materials. In addition, the roughness and the morphology of worn surface of different matching materials were quantitatively characterized.FindingsThe study revealed that material combinations have different friction performances. Test results showed that the abrasion of matching type stainless steel (SS) and SS is rather serious, and the method of surface coating could improve the friction performance of SS when friction with other materials. For matching type of SS with surface treatment (SS-ST) and SS-ST, 316L-GIC and 316L-GIC have relatively stable CoF, and the wear rate was smaller than other matching materials, while 316L-TAC and 316L-TAC has the smaller CoF than that of 316L-GIC. Matching materials 316L-GIC with PEEK-30CF of matching type SS-ST and PEEK-30CF has more stable COF and better wear resistance than those of other matching materials.Originality/valueThis research has laid a foundation for the improvement of service life and working efficiency of friction pair in HWBHM under working conditions at low speed and high pressure.