Abstract
To assess the influence of changing the size and position of lever arm on transverse and vertical bowing effects during retraction in lingual biomechanics. A three dimensional 3D finite element method was used to simulate en masse anterior teeth retraction using lingual appliance with sliding mechanics. Two groups were made, 1st group had lever arm mesial to canine while 2nd group had distal to canine. Each group had 4 subgroups with lever arm height varying from 0mm to 12mm. Displacements of the maxillary anterior teeth were noted in each group. As the Lever Arm Height (LAH) increased in group I, the vertical bowing effect reduced while the transverse bowing increased with respect to canines. In group II, both vertical and transverse bowing effects increased but transverse bowing was less as compared to group I. Strategic location of the lever arm is required in different clinical situations during en-mass retraction, keeping in mind the location of Centre of Resistance (CRes) as well as the vertical and the transverse bowing effects.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
