Abstract
Surfactants are used to lower the interfacial tension by adsorption process at the interface between oil and water. Chemical surfactants pose detrimental effects to equipment used and the environment as it consists of toxic compound. Environmentally friendly surfactant such as biosurfactant nowadays is the most sought after as perceived to be biodegradable, less toxic, high selectivity and biocompatible over chemical surfactant. In this study, stability of water-in-oil emulsion was observed using A-MeG (chemical surfactant) and Hylocereusundatus foliage (biosurfactant) at varying concentrations (samples A, B, C) via several measurement methods namely; droplet size, surface tension, rheology and creaming index. Results revealed that sample A with A-MeG and sample C with Hylocereusundatus foliage had smaller droplet sizes at 7.844 μm and 8.032 μm, respectively; lower average interfacial tension at 29.0 mN/m and 29.2 mN/m, respectively; higher average viscosity at 0.004061 mPa.s and 0.004171 mPa.s, respectively; which indicated that both were the most stable emulsion samples. Sample A with A-MeG had high creaming index, however, no water separation was recorded. While, sample C with Hylocereusundatus foliage recorded lower creaming index which indicated high stability. In conclusion, it is proven that there is a possibility of using Hylocereusundatus foliage in stabilising the water-in-oil emulsion.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
