Comparative evaluation of the effect of different bonding agents on the ultramorphology of primary tooth dentin and the resin dentin interface

Abstract

Aim:To analyze and compare the changes in the ultramorphology of dentin in primary teeth using different bonding agents and to study the resin/dentin interface produced by them.Materials and Methods:Occlusal surfaces of 50 extracted human deciduous teeth were grounded to expose the dentin. The teeth were divided into two groups (A) For viewing surface morphology- 18 teeth divided into four groups: (a) for viewing dentinal morphology (3 teeth), (b) Scotchbond multi-purpose (5 teeth), (c) Adhe SE (5 teeth), (d) Futurabond (5 teeth). (B) For viewing interfacial morphology- 32 teeth divided into four groups with 8 teeth each: (a) Scotch Bond Multipurpose (3M, ESPE),), (b) Adhe Se (Vivadent), (c) Optibond All-in-One (Kerr), (d) Futurabond NR (VOCO, Cuxhaven, Germany). The adhesives were applied to each group following the manufacturer's instruction. All the samples were then prepared for viewing under SEM.Results:The photographs were graded using a four-step (0-3) scale method proposed by Ferrari et al. For Scotchbond, 12 (75%) were graded as 2 Grade 3 was observed in only 1 observation in the entire lot of materials. The results obtained for Adhe SE and Optibond AIO were similar, i.e. in 5 (31.25%) observations each the scores were 0 and in 11 (68.75%) observations each the scores were 1. In case of Futurabond, 3 (18.75%) observations were graded as 0 and 13 (81.25%) were graded as 1, thus showing a mean score of 0.81±0.40.Conclusion:Three- step bonding agent results in the complete removal of smear layer. While the self- etch approach is not efficient in removing the smear layer and opening of the dentinal tubules. The longest resin tags with lateral branches were seen in two groups- Scotch bond multipurpose and Optibond FL.