Abstract
In vitro evaluation of the shear bond strength of composite resin bonded to enamel which is pretreated using acid etchant or pulsed Nd:YAG. Qualitative morphological changes in enamel surfaces were observed under a scanning electron microscope (SEM). 60 extracted human teeth were divided in two groups of 30 each (Groups A and B). In Group A, prepared surface of enamel was etched using 35% phosphoric acid (Scotchbond, 3M). In Group B, enamel was surface treated by a surgical Nd:YAG laser beam (Medilas 4060 Fibertom) at 0.8 W, 10 Hz, for 10 s with 80 mJ/pulse power. Bonding agent (single bond dental adhesive, 3M) was applied over the test areas on 20 samples of Groups A and B each, and light cured. Composite resin (Z 100, 3M) was applied onto the test areas as a 3 mm diameter cylinder, and light cured. The samples were tested for shear bond strength. Remaining 10 samples from each group were observed under SEM for morphological changes. The mean shear bond strength was 20.00 MPa (± 1.93) and 13.28 MPa (±1.97) for Group A and B, respectively. The difference in mean values was statistically significant between Groups A and B (P<0.001). Under SEM, Group A showed typical honeycomb appearance and Group B showed bubble-like cavities. In enamel, acid etch technique showed higher shear bond strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Indian Society of Pedodontics and Preventive Dentistry
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
