Comparative evaluation of fracture resistance of anterior provisional restorations fabricated using conventional and digital techniques - An in vitro study.

Abstract

Comparative evaluation of the fracture resistance of anterior provisional crowns fabricated by conventional and digital techniques. Department of Prosthodontic, PGIDS, Rohtak, An in-vitro - Comparative study. Thirty recently extracted maxillary central incisors were handpicked. Tooth preparation was done according to the principles of tooth preparation. A single-step impression technique was used for impression making of the prepared tooth and stone models were poured. Extracted teeth were divided into 3 groups (n = 10 each) based on provisional crown fabrication technique. A bis-acryl-based (Protemp 4 3M ESPE) resin was used to fabricate the provisional crowns by the conventional indirect technique. The rest of the stone models (20) were scanned using lab scanner (Dentsply Sirona InLab EOS X5). CAD/CAM provisional material (Dentsply Sirona multilayer PolyMethyl Methacrylate) PMMA disc was used for fabrication of provisional restoration through milling technique. 3D printed temporary provisional material (NextDent C&B resin) was utilized for 3D printed provisional crowns. Cementation of provisional crowns was done using eugenol free temporary luting cement (Templute, Prime dental). All cemented provisional crowns were subjected to load under Universal Testing Machine. The maximum load to produce fracture for each specimen was recorded in Newton (N). Shapiro-Wilk test was employed to test the normality of data. Kruskal- Wallis Test was used to compare the mean fracture resistance between all the groups. For intergroup comparison Mann-Whitney U Test was used. The mean fracture resistance of group I (Conventional technique) was found to be 558.8459700 ± 22.33 N; for group II (CAD/CAM technique) 960.8427200 ± 37.49 N and for group III (3D Printed technique) 1243.1774000 ± 68.18 N. Group I had the least fracture resistance value while group III showed maximum value. Provisional crowns fabricated using 3-D printing technique showed higher fracture resistance followed by CAD/CAM technique and conventional technique. Additive manufacturing of provisional crowns using 3-D printing technique could be considered a reliable and conservative method for the fabrication of stronger provisional restorations.