Abstract

Abstract. The TROPOspheric Monitoring Instrument (TROPOMI), launched in October 2017 on board the Sentinel-5 Precursor (S5P) satellite, monitors the composition of the Earth's atmosphere at an unprecedented horizontal resolution as fine as 3.5 × 5.5 km2. This paper assesses the performances of the TROPOMI formaldehyde (HCHO) operational product compared to its predecessor, the OMI (Ozone Monitoring Instrument) HCHO QA4ECV product, at different spatial and temporal scales. The parallel development of the two algorithms favoured the consistency of the products, which facilitates the production of long-term combined time series. The main difference between the two satellite products is related to the use of different cloud algorithms, leading to a positive bias of OMI compared to TROPOMI of up to 30 % in tropical regions. We show that after switching off the explicit correction for cloud effects, the two datasets come into an excellent agreement. For medium to large HCHO vertical columns (larger than 5 × 1015 molec. cm−2) the median bias between OMI and TROPOMI HCHO columns is not larger than 10 % (< 0.4 × 1015 molec. cm−2). For lower columns, OMI observations present a remaining positive bias of about 20 % (< 0.8 × 1015 molec. cm−2) compared to TROPOMI in midlatitude regions. Here, we also use a global network of 18 MAX-DOAS (multi-axis differential optical absorption spectroscopy) instruments to validate both satellite sensors for a large range of HCHO columns. This work complements the study by Vigouroux et al. (2020), where a global FTIR (Fourier transform infrared) network is used to validate the TROPOMI HCHO operational product. Consistent with the FTIR validation study, we find that for elevated HCHO columns, TROPOMI data are systematically low (−25 % for HCHO columns larger than 8 × 1015 molec. cm−2), while no significant bias is found for medium-range column values. We further show that OMI and TROPOMI data present equivalent biases for large HCHO levels. However, TROPOMI significantly improves the precision of the HCHO observations at short temporal scales and for low HCHO columns. We show that compared to OMI, the precision of the TROPOMI HCHO columns is improved by 25 % for individual pixels and by up to a factor of 3 when considering daily averages in 20 km radius circles. The validation precision obtained with daily TROPOMI observations is comparable to the one obtained with monthly OMI observations. To illustrate the improved performances of TROPOMI in capturing weak HCHO signals, we present clear detection of HCHO column enhancements related to shipping emissions in the Indian Ocean. This is achieved by averaging data over a much shorter period (3 months) than required with previous sensors (5 years) and opens new perspectives to study shipping emissions of VOCs (volatile organic compounds) and related atmospheric chemical interactions.

Highlights

  • Satellite observations of tropospheric formaldehyde (HCHO) columns have been used for years to support air quality and chemistry–climate-related studies from the regional to the global scale

  • This paper assesses the performances of the TROPOspheric Monitoring Instrument (TROPOMI) formaldehyde (HCHO) operational product compared to its predecessor, the OMI (Ozone Monitoring Instrument) HCHO QA4ECV product, at different spatial and temporal scales

  • Owing to its high spatial resolution resulting in many measurement points, coupled with an improved signal-to-noise ratio at the single-pixel level, TROPOMI allows us to monitor HCHO tropospheric columns from space with an unprecedented definition

Read more

Summary

Introduction

Satellite observations of tropospheric formaldehyde (HCHO) columns have been used for years to support air quality and chemistry–climate-related studies from the regional to the global scale. Satellite observations of formaldehyde columns in the troposphere have been extensively reported in the literature from a number of nadir UV sensors, e.g. the Global Ozone Monitoring Experiment (GOME; Chance et al, 2000; Palmer et al, 2001; De Smedt et al, 2008), SCanning Imaging Absorption spectroMeter for Atmospheric CHartographY (SCIAMACHY; Wittrock et al, 2006; De Smedt et al, 2008, 2010), Ozone Monitoring Instrument (OMI; González Abad et al, 2015; De Smedt et al, 2015, 2018; Kaiser et al, 2018; Levelt et al, 2018), Global Ozone Monitoring Experiment-2 (GOME-2; De Smedt et al, 2012, 2015; Vrekoussis et al, 2010; Hewson et al, 2013; Hassinen et al, 2016) and Ozone Mapping and Profiler Suite (OMPS; Li et al, 2015; González Abad et al, 2016) They are used in many studies related to air quality and climate change

OMI instrument and QA4ECV HCHO product
TROPOMI instrument and the HCHO operational product
HCHO retrieval algorithm for OMI and TROPOMI
MAX-DOAS datasets
Data use and method
TROPOMI HCHO tropospheric columns
Comparison between OMI and TROPOMI measurements
HCHO slant column precision
HCHO tropospheric columns
Validation with a global MAX-DOAS network
Direct comparisons of tropospheric columns
Sensitivity tests
Effect of vertical smoothing
Detection of weak HCHO columns over shipping lanes
Findings
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call